1988-1990 Ford Bronco Four Wheel Drive Rear OE Driveshaft Assembly - ZDS9822 USA Standard. Replacement driveshafts from USA Standard Gear provide a reliable and affordable solution when looking to replace a worn or broken driveline. Each shaft is Made in America and manufactured to strict tolerances to ensure you receive a product that is precision balanced with minimal runout.

Backed by a limited lifetime warranty, you can trust in USA Standard driveshafts to get your car, van, truck or SUV back in action. Our product range covers domestic and select foreign makes with over 600 fitments from classic rides to today's most popular models.
Details:

• Driveshaft - Rear
• 30 1/4 inch long from flange to flange
• Fits 1988-1990 Ford Bronco four wheel drive rear with automatic transmission
• Fits models with automatic transmission
• Made in the USA from Astm A513 DOM tubing
• All new OEM quality driveline ready to install

Technical Notes:

• Updated conversion driveshaft, appearance may vary from the factory design

• Compressed length of 30-1/4 inch. measured from center to center of the furthest universal joint
• 1310 universal joint at the differential
• Conversion shaft replaces the CV heads with a universal joint design and 4 bolt flange
• New universal joints, slip yokes, shafts and components ensure a long life
• All units are dynamically balanced at 3,000+ RPMs for vibration-free driving
• USA Standard Perfect Fit drive shafts are guaranteed for proper fitment and easy installation
• USA Standard Driveshafts are strengthened over common OE shafts to prevent OE failure
• Slip yokes & u-joints are lubricated with high temperature grease
• Brand new and fully assembled for simple out-of-the-box replacement

• AAP_UDA_4: 60

• Compressed Length of 30-1/4 inch. measured from flange to flange
• 4 bolt flange on each end
• Conversion design replaces non rebuildable GKN CV design.

1984-1990 Ford Bronco II (Rear) (Transmission Base Gear: 5 & Transmission Control Type: Automatic, Manual & Drive: 4WD, RWD / Note: Compressed Length of 30-1/4 inch. measured from flange to flange

• 4 bolt flange on each end
• Conversion design replaces non rebuildable GKN CV design.)